What are you building?
Fence Calculator
Posts, rails, pickets, concrete & cost in seconds.
Plan a wood or vinyl fence run with material lists, cut lists, and full cost estimates.
Start this projectGate Builder
Design single & double gates with hardware.
Frame it right the first time — sizing, sag prevention, and hinges.
Start this projectDeck Builder
Joists, beams, decking, fasteners.
Full deck framing plans with load-safe spans and premium finish options.
Start this projectShed Builder
Studs, sheathing, roof & siding.
Turn a 12×20 dream into a plan you can walk into Home Depot with.
Start this projectPergola Builder
Posts, beams, rafters, shade slats.
Backyard pergolas engineered for shade, spans, and looks.
Start this projectConcrete Slab Calculator
Bags, yards, rebar, and cost.
Slabs, footings, sonotubes, and pads — never over-order again.
Start this projectFlooring Calculator
Square footage, boxes, underlayment.
LVP, hardwood, tile — with waste and pattern factors dialed in.
Start this projectRoofing Calculator
Squares, ridge, valley, and nails.
Asphalt & metal roofing with pitch-aware waste calculations.
Start this projectDrywall & Paint Calculator
Sheets, mud, tape, gallons.
Room-by-room drywall hang and finish with primer and paint gallons by coat, openings deducted.
Start this projectRetaining Wall Calculator
Blocks, base gravel, backfill, drainage.
Segmental retaining walls with proper setback and drainage plans.
Start this projectInsulation Calculator
Batt bags, blown-in, air sealing.
Net wall area after openings, cavity count, bag counts by R-value, and ceiling coverage.
Start this projectBaseboard & Trim Calculator
Sticks of base, casing, shoe.
Room perimeter less doorways, casing per door and window, caulk, nails and trim paint.
Start this projectSiding & Exterior Calculator
Squares, soffit, fascia, gutters.
Wall and gable area net of openings, house wrap, trim, soffit, fascia and gutter runs.
Start this projectStairs & Railing Calculator
Rise, run, stringers, handrail.
Even riser layout with code checks, stringer length and count, treads, risers and balusters.
Start this projectDoor & Window Openings
Rough openings, headers, studs.
Rough opening sizes, a header starting point by span, kings, jacks, cripples and trim.
Start this projectCloset Build Calculator
Framing, drywall, shelving, rods.
Partition wall framing, drywall and finishing, shelving by material, rods and paint.
Start this projectHidden Bookcase Door
The secret door every DIYer wants.
Frame, hinge, and shelf plans for a real hidden passage.
See what's comingLandscaping Calculator
Mulch, sod, gravel, edging.
Bed volumes, coverage, and delivery-quantity math done right.
See what's comingWall Framing Calculator
Studs, plates, headers, sheathing.
Stud-by-stud framing takeoff for interior and exterior walls, including openings and LVL headers.
Start this projectConcrete Flatwork Calculator
Driveways, walks, patios, steps.
Flatwork takeoff with thickened edges, control-joint layout, base gravel, and finish materials.
Start this projectEstimating software for contractors who bid on-site
Contractors, handymen and remodelers use the same calculators to build material takeoffs, labor hours and client-ready proposals — priced to the ZIP the job is in.
- Takeoff priced to your ZIP in minutes
- Cut list that trims the lumber order
- Branded proposal and invoice PDFs
Material and cost output is an estimate, never a quote. Permit content is guidance to verify with your local building department.