How much does a concrete flatwork cost in New Mexico?
Driveways, walks, aprons and steps with joints and finish. Using New Mexico material pricing, a typical DIY concrete flatwork runs about $2,815 in materials — 2% below the national average. These are estimates only, built from our live calculator's default project size — plug in your exact dimensions for a precise shopping list.
Estimates only — not a quote.
New Mexico cost breakdown
| Estimate | Low | Typical | High |
|---|---|---|---|
| New Mexico (DIY materials) | $2,393 | $2,815 | $3,800 |
| National average | $2,441 | $2,872 | $3,877 |
New Mexico material prices run about 2% below the national average based on our regional pricing index. Based on a common-size concrete flatwork — enter your own dimensions in the calculator for an exact number.
DIY materials estimate: $2,815. Hiring a contractor in New Mexico (materials + labor at ~$47/hr) estimates to $6,936–$9,301, roughly 93 labor hours. Estimated DIY savings: $5,067 (64%).
Get your exact New Mexico price
Enter your dimensions for a precise materials list and cost — an estimate tailored to your build, not a generic average.
Frequently asked questions
Materials alone typically run $2,393–$3,800 in New Mexico for a common-size project, based on current regional material pricing. This is an estimate, not a quote — use our free calculator for numbers matched to your exact dimensions.
DIY materials run about $2,815 versus an estimated contractor range of $6,936–$9,301 (materials plus labor at the regional rate of $47/hr). That's a potential estimated savings of $5,067 (64%) by doing it yourself.
Permit thresholds vary by project type and city. Check our New Mexico permit lookup and build guide for the state-level rules before you start.
See our concrete flatwork materials and cut list page for the canonical parts list, then run the calculator with your dimensions for an exact quantity and cost breakdown.